An upcoming trend on this blog (should I manage to get back into anything resembling a habit of posting regularly) will be the Virtues and Varieties of Shelving and Storage. I'm not a believer in having tons of stuff - if I ever rent a storage unit, please slap me. I am, though, a believer in having the stuff you do have simultaneously accessible and out of the way. Shelves, appropriately sized and positioned, are a great way to do just that. Duh.
This is why I don't write for the IKEA catalog. Anymore. Curse you, Lars...
Lets skip to the end for a moment. Here's what I built:
The closet in my foyer is a small triangle, the result of doorways being re-positioned in the 50's or earlier. Its size and shape make it so even a few items on the floor rapidly became a messy pile. It also presented an interesting planning challenge, namely figuring out the angle of the triangle's apex so the shelf could fit as cleanly as possible into the back.
There's probably a more technically-adept way of pursuing this, perhaps with calipers, or a degree in mathematics, but all my geometric scratchings just resulted in a worn pencil, so I went back to trial and error. I set the miter saw to what seemed like a good angle and made two cuts:
Then I trooped back and forth between the foyer and the workshop just fitting this one piece of wood into the back corner, and altering the angles needed until it fit 'squarely'. I think I hit an acceptable fit on the third try - for many reasons, this is not an instance where extra time spent getting it justsoperfect gets you much of an improvement in end-quality.
With the angle noted, it was an easy job to knock out several more cuts using a tape measure and a combination square.
Same thing for the second grouping of boards, just without switching the miter back and forth:
This project was done mostly with two-by scrap for durability (how careful are you with the things you toss into the front hall closet?), because I had it around, and it's easy to work with and forgiving (assuming you have an accurate enough saw). The rail is an easy cut since we already know the angle; I added a piece of scrap one-by to hold the stack together more cleanly.
The two-by rail could screw directly into the wall (if I knew where the studs were), but I went with a couple of simple legs made of two-by, and a 'fancier' leg cut from an old broomstick. Using a paddle bit, I set the leg about a half-inch into the shelf...
Then screwed in cleanly from the top:
Looks pretty, eh? This is why it's nice to have piles of miscellaneous (sorted) fasteners, so you can find the right size and finish for the job.
Now I only planned on three legs - two two-bys on the long edge, and what turned out to be the broomstick - to maximize access under the shelf. I debated about the placement of the broomstick leg, ultimately deciding on the 'front' placement because I expected any unbalanced loads to be towards the front. Maybe this will prove completely wrong; if so, expect a lengthy report on the matter. In all likelihood, it won't matter a lick - with the partial triangle shape, this is a stable design even though the leg isn't placed at the center (if it was placed further 'out', tipping would be quite possible).
Next week: more projects that take longer to post than to complete.
